Feed speed overrides are application default

[sfmissionmark]

Currently feed speeds stick per application level.

I think this would be better as a file level preference. If I am running through a soft maple wood I sometimes bump the speeds up to get through it a little faster. The next time I open a new file those speeds stick with the new file. It's ultimately better to write correct g-code with proper speeds we should honor those speeds unless overridden purposely.

Thanks,
Mark

[figamore]

FluidNC (at least in their latest version) explicitly resets feed, rapid, and spindle overrides to their defaults on both M2 and M30. I was unable to reproduce this issue and can see that the overrides are always reset to their defaults upon job completion.

[sfmissionmark]

These are currently still sticking even after a reboot for me. I will upgrade and see if it stops.