Skip to content
Open
Changes from all commits
Commits
File filter

Filter by extension

Filter by extension

Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
111 changes: 106 additions & 5 deletions arch/arm64/boot/dts/exynos/google/gs201-panther.dts
Original file line number Diff line number Diff line change
Expand Up @@ -180,17 +180,41 @@
};

/*
* Sub PMIC, the fingerprint sensor's supply only: L15S_UDFPS_AVDD
* with stock's 2.5-3.3 V range (stock dtbo 0x30406, LDO15S, the
* same as the Pixel 7 Pro's). Only described rails can be switched;
* the others stay as the bootloader set them. Disabled until the
* fingerprint overlay, which enables its own rail.
* Sub PMIC, for the fingerprint sensor's and the GNSS receiver's
* supplies: L15S_UDFPS_AVDD with stock's 2.5-3.3 V range, and
* L9S_GNSS_CORE, L10S_GNSS_RF and L11S_GNSS_AUX with stock's ranges
* (stock dtbo 0x30406, the same as the Pixel 7 Pro's), so
* registering them sets no voltage. Only described rails can be
* switched; the others stay as the bootloader set them. Disabled
* until the fingerprint or GNSS overlay, each of which enables its
* own rails.
*/
pmic-2 {
compatible = "samsung,s2mpg13-pmic";
status = "disabled";

regulators {
ldo9s: ldo9s {
regulator-name = "vdd_gnss_core";
regulator-min-microvolt = <725000>;
regulator-max-microvolt = <1300000>;
status = "disabled";
};

ldo10s: ldo10s {
regulator-name = "vdd_gnss_rf";
regulator-min-microvolt = <1600000>;
regulator-max-microvolt = <1950000>;
status = "disabled";
};

ldo11s: ldo11s {
regulator-name = "vdd_gnss_aux";
regulator-min-microvolt = <1600000>;
regulator-max-microvolt = <1950000>;
status = "disabled";
};

ldo15s: ldo15s {
regulator-name = "vdd_udfps";
regulator-min-microvolt = <2500000>;
Expand Down Expand Up @@ -516,6 +540,83 @@
};
};

/*
* GNSS: Broadcom BCM4775x on PERIC0 USI5 SPI, wired as on the Pixel 7 Pro:
* the stock panther dtbo's spi5 node, its bcm4775@0 child (26 MHz, mode 3)
* and the four GPS pin groups are identical to the cheetah dtbo's (host_req
* gpa6-4, mcu_req gpp4-3, mcu_resp gph2-2, nstandby gph2-3), so this is
* cheetah's node. Chip select is driven as a GPIO. Disabled until
* omarchy-mobile's device/panther/overlays/gnss.dtso, which also has to turn
* on gph2's pin controller (pinctrl_hsi2, disabled in gs201.dtsi) for
* mcu_resp and nstandby; the driver keeps the chip in standby and its rails
* off until /dev/ttyBCM is opened.
*/
&usi5 {
samsung,mode = <USI_MODE_SPI>;
};

&spi_5 {
pinctrl-0 = <&spi5_bus &spi5_cs_gpio>;
cs-gpios = <&gpp10 3 GPIO_ACTIVE_LOW>;
num-cs = <1>;

gnss@0 {
compatible = "brcm,bcm4775-gnss";
reg = <0>;
spi-max-frequency = <26000000>;
spi-cpol;
spi-cpha;
interrupts-extended = <&gpa6 4 IRQ_TYPE_LEVEL_HIGH>;
/* Raw levels: lhd writes 1 to the nstandby attribute to run it */
nstandby-gpios = <&gph2 3 GPIO_ACTIVE_HIGH>;
mcu-req-gpios = <&gpp4 3 GPIO_ACTIVE_HIGH>;
mcu-resp-gpios = <&gph2 2 GPIO_ACTIVE_HIGH>;
host-req-gpios = <&gpa6 4 GPIO_ACTIVE_HIGH>;
vddcore-supply = <&ldo9s>;
vddrf-supply = <&ldo10s>;
vddaux-supply = <&ldo11s>;
pinctrl-0 = <&gnss_nstandby &gnss_mcu_resp &gnss_mcu_req
&gnss_host_req>;
pinctrl-names = "default";
};
};

&pinctrl_hsi2 {
gnss_mcu_resp: gnss-mcu-resp-pins {
samsung,pins = "gph2-2";
samsung,pin-function = <GS101_PIN_FUNC_INPUT>;
samsung,pin-pud = <GS101_PIN_PULL_DOWN>;
samsung,pin-drv = <GS101_PIN_DRV_2_5_MA>;
samsung,pin-con-pdn = <GS101_PIN_PDN_PREV>;
samsung,pin-pud-pdn = <GS101_PIN_PULL_DOWN>;
};

gnss_nstandby: gnss-nstandby-pins {
samsung,pins = "gph2-3";
samsung,pin-pud = <GS101_PIN_PULL_NONE>;
samsung,pin-drv = <GS101_PIN_DRV_2_5_MA>;
samsung,pin-con-pdn = <GS101_PIN_PDN_PREV>;
samsung,pin-pud-pdn = <GS101_PIN_PULL_NONE>;
};
};

&pinctrl_peric0 {
gnss_mcu_req: gnss-mcu-req-pins {
samsung,pins = "gpp4-3";
samsung,pin-pud = <GS101_PIN_PULL_NONE>;
samsung,pin-drv = <GS101_PIN_DRV_2_5_MA>;
};
};

&pinctrl_far_alive {
gnss_host_req: gnss-host-req-pins {
samsung,pins = "gpa6-4";
samsung,pin-function = <GS101_PIN_FUNC_EINT>;
samsung,pin-pud = <GS101_PIN_PULL_NONE>;
samsung,pin-drv = <GS101_PIN_DRV_2_5_MA>;
};
};

/*
* Goodix optical under-display fingerprint sensor, as on the Pixel 7 Pro:
* the stock dtbo for board 0x30406 has the same goodixfp node as cheetah's
Expand Down