Skip to content
Merged
Changes from all commits
Commits
File filter

Filter by extension

Filter by extension

Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
97 changes: 97 additions & 0 deletions arch/arm64/boot/dts/exynos/google/zuma-akita.dts
Original file line number Diff line number Diff line change
Expand Up @@ -47,6 +47,23 @@
enable-active-high;
};

/*
* The pack, for the fuel gauge and the charger cell. 4486 mAh is the
* design capacity the stock phone's gauge reports
* (charge_full_design); Google's charger node names 4404 mAh. The
* charge limits are deliberately below stock's 4.48 V
* (google,fv-max-uv): 4.2 V and about 0.3 C, as on the Pixel 8 Pro,
* until a review raises them.
*/
battery: battery {
compatible = "simple-battery";
charge-full-design-microamp-hours = <4486000>;
voltage-max-design-microvolt = <4480000>;
voltage-min-design-microvolt = <3300000>;
constant-charge-voltage-max-microvolt = <4200000>;
constant-charge-current-max-microamp = <1320000>;
};

chosen {
/*
* ABL requires bootargs to exist; it appends its own after these.
Expand Down Expand Up @@ -150,6 +167,9 @@
&acpm_ipc {
pmic-1 {
compatible = "samsung,s2mpg14-pmic";
interrupts = <GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>;
google,vgpio2ap-sysreg = <&sysreg_vgpio2ap>;
wakeup-source;

regulators {
touch_avdd: ldo4m {
Expand All @@ -167,6 +187,75 @@
};
};

&cmu_peric1 {
status = "okay";
};

/*
* The battery pack's EEPROM, as on the Pixel 8 Pro: an at,24c08 at 0x50
* (Google's zuma-akita-battery.dtsi, pack_bee). Byte 0x17 is the battery
* ID that picks the fuel gauge's model. Read-only; the bus stays off
* here and a bring-up overlay switches USI9 and hsi2c_9 on.
*/
&hsi2c_9 {
clock-frequency = <400000>;

eeprom@50 {
compatible = "atmel,24c08";
reg = <0x50>;
pagesize = <16>;
read-only;
};
};

/*
* The MAX77759's fuel gauge (0x36) and PMIC (0x66, which also holds the
* charger at 0x69), as on the Pixel 8 Pro (Google's
* zuma-akita-battery.dtsi: the same addresses, interrupts gpa7-7 and
* gpa8-0, and a 5 mOhm sense resistor). The bus pins are pulled up, as
* the stock phone's live device tree has them. Binding the PMIC at 0x66
* also creates its charger cell, and the charger driver then programs
* charge limits from the battery node, so max77759_charger,
* gpio_max77759, nvmem_max77759 and tcpci_maxim have to be kept from
* loading: the akita device package blocks them (omamobile-max77759.conf,
* omarchy-mobile#718), so install it with this DTB. The Type-C controller
* at 0x25 isn't described yet.
*/
&hsi2c_11 {
clock-frequency = <400000>;
status = "okay";

fuel-gauge@36 {
compatible = "maxim,max77759-fg";
reg = <0x36>;
interrupts-extended = <&gpa7 7 IRQ_TYPE_LEVEL_LOW>;
pinctrl-0 = <&if_pmic_fg_int>;
pinctrl-names = "default";
shunt-resistor-micro-ohms = <5000>;
monitored-battery = <&battery>;
};

pmic@66 {
compatible = "maxim,max77759";
reg = <0x66>;
interrupts-extended = <&gpa8 0 IRQ_TYPE_LEVEL_LOW>;
pinctrl-0 = <&if_pmic_int>;
pinctrl-names = "default";
interrupt-controller;
#interrupt-cells = <2>;
/* for the charger cell */
monitored-battery = <&battery>;

gpio {
compatible = "maxim,max77759-gpio";
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
};

&spi20 {
status = "okay";

Expand All @@ -193,6 +282,10 @@
};
};

&sysreg_peric1 {
status = "okay";
};

/*
* Behind the init's storage guard (only slot B's boot images and userdata
* writable), which sets every partition read-only before anything mounts
Expand Down Expand Up @@ -222,3 +315,7 @@
&usi2_hsi0 {
status = "okay";
};

&usi11 {
status = "okay";
};