STM32 Blue Pill (Arduino IDE) program for ZH03B Laser Dust Sensor and Serial Monitor Application (works for non-authentic STM32 Blue Pill)
!!! DISCLAIMER: The Particle Sensor module I was working with seemed to be faulty so I could never get any readings out of it. Any feedback would be appreciated. !!!
Prerequisites:
- STM32 Blue Pill
- ST-LINK/V2
- USB-TTL Adapter
- Winsen ZH03B Laser Dust Sensor
- STM32 Software Suite installed and configured
- Arduino IDE
STM32F103 Pinout - https://lh6.googleusercontent.com/wYhAmRIfTgBSWtNt7KT8db70NY2XtEbobHzeHcdPY3SFLKqqIdhgkFJfxikIP2G-J9E6-mFcK-SjpiPfQuUv9yWdaE79o6oB-nglBWmMOmzwL2evWBQ9_uPq08BurhDM0pPziF4
Use "HardwareSerial.h" library to activate USART2 and USART3. USART1 is activated by default.
ZH03B Datasheet - https://www.winsen-sensor.com/d/files/air-quality/zh03-series-laser-dust-module-v2_0.pdf
Installing STM32 Add-on in Arduino IDE - https://www.sgbotic.com/index.php?dispatch=pages.view&page_id=48
Arduino IDE configurations (in the "Tools" menu):
- Debug symbols and core logs: "None"
- Optimize: "Smallest (-Os default)"
- Board part number: "BluePill F103C8"
- C Runtime Library: "Newlib Nano (default)"
- Upload method: "STM32CubeProgrammer (SWD)"
- USB support (if available): "None"
- U(S)ART support: "Enabled (generic 'Serial)"
- USB speed (if available): "Low/Full Speed"
- Use the ST-LINK/V2 to upload program onto the board from the IDE (COM port grayed out in the "Tools" menu or "not connected" status for the board is normal)
- Remove the ST-LINK/V2 connection from the computer and use the TTL Adapter to connect to the Serial Monitor on the IDE (COM port and board status should now be visible)
- Make sure RX of the board is connected to the TX of the TTL Adapter and vice-versa
- If both ST-LINK/V2 and TTL Adapter are connected to the computer at the same time, the IDE may default to using the TTL Adapter to upload the program and give an error