I just pulled the latest firmware again, and I get stuck in a reboot loop after saving the settings. I am in the US and using a Heltec v4:
- Flash Device
- Reboot
- Setup via wifi
- Save and reboot
- Every ~1 minute the device will come online, get an IP address via wifi, and then reboot
This happens regardless of battery power or USB plugged in.
Here is the exact build I am using on the hardware side. This does not happen with MT firmware:
https://meshnology.com/collections/heltec/products/meshnology-n39-wifi-lora-32-v4-development-kit-3000mah-battery-863-928mhz-antennas
I just pulled the latest firmware again, and I get stuck in a reboot loop after saving the settings. I am in the US and using a Heltec v4:
This happens regardless of battery power or USB plugged in.
Here is the exact build I am using on the hardware side. This does not happen with MT firmware:
https://meshnology.com/collections/heltec/products/meshnology-n39-wifi-lora-32-v4-development-kit-3000mah-battery-863-928mhz-antennas