In the Mesh RF section of the Basic Setup page the Enable checkbox would make more sense if it were below the Netmask field. Unchecking the box still allows for the DTD connection, whereas now you would expect that it disables everything because it is above IP address. You might also consider separating the two areas with a blue line. Above the IP address you might call that section DTD and below that Mesh RF. This confusion is due to non-standard checkbox usage. For example, the Gnome design guidelines say, "If toggling a check box affects the sensitivity of other controls, place the check box immediately above or to the left of the controls that it affects. This helps to indicate that the controls are dependent on the state of the check box."
In the Mesh RF section of the Basic Setup page the Enable checkbox would make more sense if it were below the Netmask field. Unchecking the box still allows for the DTD connection, whereas now you would expect that it disables everything because it is above IP address. You might also consider separating the two areas with a blue line. Above the IP address you might call that section DTD and below that Mesh RF. This confusion is due to non-standard checkbox usage. For example, the Gnome design guidelines say, "If toggling a check box affects the sensitivity of other controls, place the check box immediately above or to the left of the controls that it affects. This helps to indicate that the controls are dependent on the state of the check box."