Hi again,
I found that after reset, though the number in the blank will be set to zero. However, when I issue another command, the monitor shows the original output and then increase. So I should minus the output after one command and the output before this command to get the command's read/write cmd count and so on. Is it the right logic? I'm curious about it. If it's right, then the reset is useless , I think.
Hi again,
I found that after reset, though the number in the blank will be set to zero. However, when I issue another command, the monitor shows the original output and then increase. So I should minus the output after one command and the output before this command to get the command's read/write cmd count and so on. Is it the right logic? I'm curious about it. If it's right, then the reset is useless , I think.